HALTECH HYUNDAI GENESIS PRO PLUG-IN STANDALONE

Fully Programmable
The Haltech Genesis ECU is a standalone fully programmable replacement for the factory ECU.
It bolts into the factory location and plugs into the standard harness without the need for modification or extra wiring.
Utilizing the OEM hardware, making the Haltech Genesis ECU is a true Plug ‘n Play solution.

Drive By Wire Control
The Haltech Genesis ECU has full control over the electronic throttle, allowing the user to improve the throttle response over the factory ECU.
Up to 100% throttle is now achievable under all conditions and the pedal to throttle relationship can also be adjusted.

Variable Cam Timing
The Haltech Genesis ECU has full control over both the intake and the exhaust camshafts.
With a user definable target table for each camshaft, complete control is now achievable resulting is large mid range power gains.

OBDII Support
The Haltech Genesis ECU has OBDII compatibility, allowing generic scan tools to communicate directly with the Haltech ECU via the OBDII port.
Real time data as well as DTC’s (diagnostic trouble codes) can be read and erased just like the OEM ECU.

E85 Support
The Haltech Genesis ECU has E85 compatibility when a GM Flex Fuel sensor is used.
Fuel, Ignition and Boost can all be adjusted against ethanol content, allowing the engine to run correctly with any ethanol mixture.

Features:
• Direct plug and play replacement of the OEM ECU, no re-wiring necessary.
• Uses the cars factory sensors
• Supports Sequential Injection (peak and hold) and Direct fire ignition
• Windows 2000, XP, Vista, Windows 7 compatible software
• Real time programming, instant hesitation free adjustment while engine is running
• Fully user definable 32 x 32 mapping
• Tuning via Volumetric Efficiency (VE), Injection time or Lambda Correction (MAF)
• Diagnostic trouble code storing & Check engine light control(Access through laptop only )
• Selectable onboard internal MAP sensor rated to 150kPa (up to 1.5 Bar or 22psi boost)
• Wideband “auto tuning” using user definable target AFR table
• USB and CAN Communication Port

Factory Outputs:
• 4 x Fuel Injector outputs
• 4 x Ignition outputs
• VTEC, Coolant Gauge, AC Clutch Relay,  Idle Control
• Thermo Fan,  Check Engine Light,  Fuel Pump

Factory Inputs:
• MAP sensor,  Throttle Position Sensor, Knock Detection sensor,
• Coolant Temperature sensor, Vehicle Speed Sensor,
• Air Temperature sensor, Power Steering Switch, Narrowband Oxygen sensor

Expansion I/O*:
• 2 x Analogue Voltage inputs
• 2 x Analogue Temperature inputs
• 4 x Digital Outputs

*Optional auxiliary harness required to be purchased Haltech Part # HT040003

Functions:
• Closed Loop O2 Control
• Decel Cut Over Boost Rev Limiter
• Closed & Open Loop Boost Control
• Gear Setup
• Transient Throttle Enhance
• Knock Control
• Long Term Fuel Trim

Correction Tables:  Fuel  Ignition  Boost:
• Cranking
• Air Temp Target Correction
• Zero Throttle Gear Correction
• Cylinder Trim
• TPS Correction
• Generic Correction 1
• Generic Correction 2
• Gear Correction
• Post Start
• Air Temp Duty Correction
• Post Start

Miscellaneous:
• Data Logging: 448Kb of onboard data logging, Storage for approx 40 minutes at 10 logs per seconds,
6 channels of data
• Max 20 channels logging capability
• Tune can be password protected in software
• Rugged anodized aluminum casing